For NetLink (Ethernet) based systems; the NetLink board firmware can be updated using this feature. This impacts switching control and communications. Before using this feature, make sure that the correct “.s19” file is located in the DIT-MCO folder. Also ensure that DitNLA is running and that a valid association with an analyzer exists. Once the feature is started, the user will be given a warning. If the user chooses to proceed, an open file dialog will be shown to the user.
Warning: Improper installation of different firmware can render the Analyzer inoperative. Contact DIT-MCO for guidance and instructions to ensure proper procedure and correct firmware version is installed.
Source: NETS User Manual, Revision D, document 132-06035-0006, section 8.2.3.5.